Cisco 300-120 Certification Exam Sample Questions and Answers

CCNP Wireless Dumps, 300-120 Dumps, Cisco WLSI PDF, 300-120 PDF, CCNP Wireless VCE, Cisco CCNP Wireless Questions PDF, Cisco Exam VCE, Cisco 300-120 VCE, CCNP Wireless Cheat SheetBefore you write the Cisco CCNP Wireless (300-120) certification exam, you may have certain doubts in your mind regarding the pattern of the test, the types of questions asked in it, the difficulty level of the questions and time required to complete the questions. These Cisco Certified Specialist - Wireless Advanced Solutions (WLSI) sample questions and demo exam help you in removing these doubts and prepare you to take the test.

The best approach to pass your Cisco 300-120 exam is to challenge and improve your knowledge. To test your learning and identify improvement areas with actual exam format, we suggest you practice with Premium Cisco 300-120 Certification Practice Exam. The practice test is one of the most important elements of your Implementing Cisco Wireless Advanced Solutions (WLSI) exam study strategy to discover your strengths and weaknesses, to improve your time management skills and to get an idea of the score you can expect.

Cisco 300-120 (WLSI) Sample Questions:

01. In aWIPS, which feature is designed to ignore the crafted packets from an attacker and protect a legitimate client from loss of connectivity?
a) Location
b) Blacklist
c) Containment
d) Auto-immune
 
02. You installed a brand-new firewall between your WLC and CMX appliance. Now your CMX service does not get location updated anymore. What port needs to be opened on the firewall for location information to flow through?
a) TCP 16113
b) UDP 5246
c) UDP 5247
d) TCP 1812
 
03. Can you perform real-time aWIPS with an AP in Sniffer mode?
a) No, aWIPS is only active if the AP is set to WIPS mode with Monitor submode.
b) No, aWIPS requires Local or Monitor mode.
c) Yes, aWIPS works seamlessly with all AP modes and submodes.
d) Yes, you can if the AP is assigned to an aWIPS zone in CMX.
 
04. Suppose a WLC has been configured for multicast-multicast mode. Which of the following actions must each AP take to participate in multicast traffic delivery?
a) Merely join the WLC with a CAPWAP tunnel.
b) Send CAPWAP packets with the WLC’s multicast group address as the destination.
c) Learn the WLC’s CAPWAP multicast group address and then send an IGMP membership report to join that group.
d) Enable a virtual interface that uses the CAPWAP multicast group address.
 
05. How does a C9800 redirect ACLs to ensure that traffic targeting the CMX IP address is redirected to CMX?
a) With a specific permit instruction
b) With a specific deny instruction
c) With a final permit any wrapper
d) With a final (implicit) deny any wrapper
 
06. A networking associate wonders if changing an access point’s (AP’s) mode from FlexConnect to Local mode causes the AP to reboot and rejoin the wireless LAN controller after a few minutes. What can you tell the networking associate?
a) Changing an AP from Local to FlexConnect mode does not cause a reboot, but changing from FlexConnect to Local mode would cause a reboot.
b) Changing an AP from Local to FlexConnect mode causes a reboot, but changing from FlexConnect to Local mode would not cause a reboot.
c) Changing an AP from Local to FlexConnect mode or from FlexConnect to Local mode is transparent and never causes a reboot.
d) Changing an AP from Local to FlexConnect or from FlexConnect to Local mode always causes a reboot.
 
07. What is the mandatory bandwidth requirement for connecting Cisco Spaces Connector to Cisco Spaces?
a) 250 Kbps
b) 2 Mbps
c) 4 Mbps
d) 8 Mbps
 
08. During a validation site survey, you face an issue where a low-end client can hear the AP, but the AP does not detect the client when it reaches the edge of the cell. Which of the following configured elements might cause this issue?
a) MAC filtering
b) CleanAir
c) EDRRM
d) RxSOP
 
09. Where can you find the Peer Comparison option in Cisco Catalyst Center?
a) Trends and Insights menu
b) Troubleshooting menu
c) Access Point Health menu
d) Third-party dashboard
 
10. Which of the following is an additional role available for account management of guest WLANs in Cisco WLC?
a) MONITOR
b) CONTROLLER
c) SECURITY
d) LOBBY

Solutions:

Question: 01

Answer: d

Question: 02

Answer: a

Question: 03

Answer: b

Question: 04

Answer: c

Question: 05

Answer: b

Question: 06

Answer: a

Question: 07

Answer: c

Question: 08

Answer: d

Question: 09

Answer: a

Question: 10

Answer: d

Note: If you find any error in these Implementing Cisco Wireless Advanced Solutions (WLSI) sample questions, you can update us by write an email on feedback@nwexam.com.

Rating: 4.8 / 5 (80 votes)